threestar40
09-25-2005, 06:37 PM
Got the bottom end put together today...everything went perfectly.
Lunati Promod 6.125" rods.
JE pistons with floating pins retained by wire locks.
Eagle 4340 non-twist crank (very nice piece by the way).
Speed Pro rings .018 on the top ring .012 on the bottom.
I probably should have gone about .002 more on each ring, but I didn't.
I'm betting the motor it will be Ok. :_paranoid
Here was the scene in my life today:http://threestar40.home.mindspring.com/spinningassembly%20001.jpg
http://threestar40.home.mindspring.com/spinningassembly%20004.jpg
Tomorrow, more progress.
Rick :lateral:
Lunati Promod 6.125" rods.
JE pistons with floating pins retained by wire locks.
Eagle 4340 non-twist crank (very nice piece by the way).
Speed Pro rings .018 on the top ring .012 on the bottom.
I probably should have gone about .002 more on each ring, but I didn't.
I'm betting the motor it will be Ok. :_paranoid
Here was the scene in my life today:http://threestar40.home.mindspring.com/spinningassembly%20001.jpg
http://threestar40.home.mindspring.com/spinningassembly%20004.jpg
Tomorrow, more progress.
Rick :lateral: