spinning assembly done.

[threestar40]

Got the bottom end put together today...everything went perfectly.

Lunati Promod 6.125" rods.
JE pistons with floating pins retained by wire locks.
Eagle 4340 non-twist crank (very nice piece by the way).

Speed Pro rings .018 on the top ring .012 on the bottom.

I probably should have gone about .002 more on each ring, but I didn't.

I'm betting the motor it will be Ok.

Here was the scene in my life today:



Tomorrow, more progress.

Rick

[slow4dr]

Originally Posted by threestar40

Got the bottom end put together today...everything went perfectly.

Lunati Promod 6.125" rods.
JE pistons with floating pins retained by wire locks.
Eagle 4340 non-twist crank (very nice piece by the way).

Speed Pro rings .018 on the top ring .012 on the bottom.

I probably should have gone about .002 more on each ring, but I didn't.

I'm betting the motor it will be Ok.

Here was the scene in my life today
Tomorrow, more progress.

Rick

Thanks for the update Rick!

[XcYZ]

Progress.

[lil427z]

rick .keep up the good work .
rick kirkindall

[hotwheels]

that look's awesome.........