Item Location (City/State): Nashville, TN
Price: $600
Description:
I intended to install these on my '69 Chevelle project; however am going with Wilwood 14" brakes instead to match my rear brakes from them.
Pair of 2008 Z06 6 piston Calipers
One caliper (silver) is new in the box. The other caliper is used (yellow) and has some light wear/tear on it. My intention was to powdercoat them black anyway.
$600 shipped for both calipers to the lower 48
Pair of DBA500 bad ass rotors
One DBA5000 rotor is super low mileage and is used; however when measured is still within
new specs and has no ridges etc. The aluminum rotor hat is discolored and doesn't match the new one I bought perfectly. So you can either live with it or have it powdercoated which shouldn't cost more than $30-40. The 2nd DBA5000 rotor I purchased is new and is the drilled and slotted style.
https://www.summitracing.com/parts/d...dVuxoCCCHw_wcB
They are $475 on Summit each.
I'll take $650 shipped for both to the lower 48 states.
Recap:
Both calipers $600 shippped
Both rotors $650 shipped
to the lower 48 states
__________________
Project: 1969 Chevelle, alum 5.3, GTS76 turbo, Chiseled Perf A/W intercooler, Holley Dominator EFI, Davis TC, JRi coilovers, 14" brakes, T56 Magnum. CTS-V Recaro seats!
Coffey Fabrication Nashville, TN doing the fabwork! 800rwhp+/25mpg+/9's@150mph goal
https://lateral-g.net/forums/showthread.php4?t=52976
1993 Mazda FD RX-7, built LS7, T56 Magnum, Holley HP, Davis Tech TC, 8.8" 3.73 Cobra IRS diff, DSS axles, Ohlins coilovers, big brakes.
CCW 18x11 front 315/30/18's and 18x12.5 rear on 335/30/18 RA1's,
2850lbs
10.31@137mph 165mph Shift-Sector 1/2 mile speed
441ci AllPro headed motor and 200lb weigh reduction in the works....
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
(2) C6 Z06 calipers and DBA5000 rotors
Linear Mode
