Billet mount for A/C dryer?

[69hugger]

Does anyone know where to find a billet mount to attach a 2.5" diameter A/C receiver to a flat surface (Rad support)?
Something like this, but with a 2.5" hole?



I hate to make something, or have it made if I can find an off the shelf item. Have searched the web, but found nothing yet.

Thanks for your ideas!

Bill

[Vince@Meanstreets]

We used a reservoir tank clamp, the ID was 2 7/8 and used plastic sleeve and a rubber as an isolator to make up the space. I believe it was a billet specialties piece. I bought it at a swap meet.

[Ricochet]

Street and Performance make one. On Page 49

http://www.hotrodlane.cc/2015%20Catalog.htm#p=50

[69hugger]

I knew somebody must have them. One or the other will work.

Thanks to you both!

Bill