67-69 Camaro Roddoors door panels

[blazincopper]

Anybody using the roddoor panels - they look pretty good, but wondering if anybody had any pros or cons about the product?

[214Chevy]

I had them in my Chevelle and had them covered in leather. I was pleased with them. Only reason I don't have them anymore is I'm switching up my interior. Not a bad product. I would have no problem recommending them.

[LSX67]

I think they went out of business back in 2009.

[blazincopper]

Originally Posted by LSX67

I think they went out of business back in 2009.

I found a couple places that still sell the panels.

[JMitch19]

I have them in my car. They aren't bad, but they make the high beam switch almost useless and if it's a manual trans car they don't give you a lot of room. If I had it to do over again I think I would go with the screaming performance panels.

[Boss 5.0]

Originally Posted by blazincopper

I found a couple places that still sell the panels.

Where??

[blazincopper]

Originally Posted by Boss 5.0

Where??

http://www.roddoors.com/pages/camaro.html

[Stilo]

Has any one bought from that web site recently?

[Northeast Rod Run]

Originally Posted by blazincopper

I found a couple places that still sell the panels.

Originally Posted by Boss 5.0

Where??

Originally Posted by blazincopper

http://www.roddoors.com/pages/camaro.html

As it's already been stated on here, they went out a business a while ago. I'm sure if you call that phone number it's going to be out of service. They just never took down their webpage

[Stilo]

I knew it was too good to be ture!