DSE Quadralink for 1st gen F-body, Corvette brakes

[Matt@BOS]

Time to clean things out!

I've got a Quadralink with a powder coated 9" axle housing with Moser 31 spline axles. The the axle housing and axles were run on my car before I switched over to a full floater. They have roughly 5,000 miles on them. The housing is powder coated black. It does have a scratch on it from being towed. If you aren't too picky, you can just touch it up with a little semi-gloss black.

All of the bracketry for the quadralink, i.e. control arms, mounting pockets, etc. are all brand new.

Asking $2,800 for this as is.

If you want a complete kit, that isn't a problem as Best of Show is a dealer for DSE and can provide whatever other parts you would like. Additional parts would sell at retail.

Also up for sale are brakes:
C6 Z06 brakes, front and rear. Powder coated gray. Asking $1200
C6 Z51 rear brakes. These brakes have less that 5 miles of use. I was test driving them when I got hit in the passenger fender: $400
Parking brake assembly for 9" with bracketry for C6 brakes: $300 - SOLD
I will throw in whatever brake pads I have on my shelf.

Will get pictures up soon,

Matt

[Hugger67RSSS]

PM Sent on brakes.

[elitecustombody]

Matt, have pics of the parking brake setup for C6 9"?Will it work with ZO6 calipers?

[JON Q]

Pm Sent

[4mm]

Pm sent on DSE stuff

[mrr1999]

PM sent

[firstgencam]

Send pics of quadralink and 9" to [email protected]

Thanks

[Gandalf]

I think I started everyone cleaning out their leftover parts lol! Between you, me and Steve there should be a lot more room in the shop by the end of the week lol! Please take pictures of everything and email to me - lol - j/k. GLWS.

[Matt@BOS]

Ok guys, I've gotten a surprising amount of interest today, so after I get pics up, I'll go back and figure out who inquired first and go by times just to be fair.

Here a few pictures, I'll get more tomorrow for the quadralink as most of it is boxed up right now.






Just to answer a few question and clear up a few things, first, the parking brake assembly will work for a 9" but could probably be used on a 10/12 bolt if Tobin will source the correct retaining plates. Second, the parking brake assembly will work for either of the rear brake setups.

Lastly, I never mentioned anything about shipping. All items will ship at buyer's expense. If you're in SoCal we can easily arrange pickup/delivery. I tend to drive around a lot.

Matt

[Carbo]

I too am interested in the DSE. Add me to your list and I also would like to see photos.