Brand New Baer Extreme+ 6S brake system (C5/C6, Ford 9")

[TOURT]

Guys,

I have had this for awhile, planned to use it on my Morrison front clip... but now everything is for sale

This will fit c5, c6, DSE, or ATS front spindles!

Front is a Baer Extreme+ 6S, this is a monoblock 6 piston caliper mounted to a 14" slot, drill, zinc plated 2pc rotor. The calipers are the rare hard anodized finish (no longer offered by Baer). The center hats were also done in a hard anodized natural finish. Front system would normally list for $2995.00

Rear is a Baer Extreme+ 6S, same hard anodized finish with custom hard anodized hats. The rear is for an early Ford Big Bearing (not Torino) and is NON park brake. If someone has a different rear flange (Torino etc) I can probably have the brackets swapped.

If someone was dead set on park brake I can also work something out, though the hats would have to change to a standard black finish and would cost extra. The rear would normally list for $2995.00

I have pics, just not sure how to post them on here.. so if someone wants them please e-mail me direct at [email protected].

These complete with all hardware, pads etc.

This is $6k in brakes new. I am looking to get $4000 firm + shipping for front and rear.

e-mail with any questions.

[DFRESH]

Dude--that is a great deal---if someone has the right setup---. Are the rear's 14 inch also?

[TOURT]

Thx I think so as well!

Yep, 14" rears as well.

Thx!

[214Chevy]

Maaan, an insane deal. I don't see these lasting long. Wish I had $4k.

[TOURT]

Pics sent to those who requested them!

I am going to take some better ones tonight as well.

Thx!

[TOURT]

Sale pending!!!

thx guys!