Saw use on my turbo car....4" pipe was attached to the 5" pipe coming from the turbo, and the exhaust tip you see exited through a cutout in the passenger fender. I'm not the original owner, but I dont think Mark used it a whole lot.....he worked on the car more than he raced it or drove it I think...lol. You could pair it with another one, but best use will be another turbo car I believe. The piece of 4" pipe attached to the collector has been clearanced a bit as you can see in the pic. The collector could be cut off and reused if that doesnt work for your app.
any interest? This could also be installed into an X or H pipe for any car......pull up to any stop light and open her up...watch them studiously ignore you and NOT look over.
__________________
1973 Trans Am
73 455 SR block, ported 6x-8 heads, solid cam, Victor intake, 830 CSU carb, aluminum rods
oh.......did I mention the 77mm Garrett turbo and methanol injection?
886 hp at the rear wheels, 1064 at the flywheel (calculated)@5500 rpm, before the methanol injection was added. Thank you Mark L...
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
BadlanzHPE 4" electric exhaust cutout
Linear Mode
