where to get a 4" oval to 3" round throttle body reducer? - Lateral-g Forums

**Flash68** · #1 04-30-2009, 08:54 PM

I think I explained that right! Have the Holley StealthRam intake with 1000cfm TPI-style throttle body (about 4" oval) that needs to connect to 3" IC plumbing. Can't find where to get this piece..... any help?

thanks

ironworks · #2 04-30-2009, 08:59 PM

two pieces of 3 inch tubing and a cut off wheel and a welder. pretty easy deal.

Rodger

**Flash68** · #3 04-30-2009, 09:03 PM

Quote:

Originally Posted by ironworks

two pieces of 3 inch tubing and a cut off wheel and a welder. pretty easy deal.

Rodger

Hey Rodger. I thought someone made this part? So it's a custom deal only?

thedugan · #4 05-01-2009, 03:57 AM

I need the same piece.

J2SpeedandCustom · #5 05-01-2009, 06:16 AM

Will one of these work? http://www.burnsstainless.com/OvalTu...valtubing.html scroll down to the bottom of the page an oval to round transition.

ironworks · #6 05-01-2009, 07:28 AM

Those are all the same od in and out, just a change in profile.

**Flash68** · #7 05-01-2009, 09:40 AM

Yep, I checked the Burns site too but all I can find anywhere so far is a 4" oval to 4" round transition....

awr68 · #8 05-02-2009, 08:47 PM

I swear I have seen them in silicone.....But can't find them now!

**Flash68** · #9 05-02-2009, 09:07 PM

Quote:

Originally Posted by awr68

I swear I have seen them in silicone.....But can't find them now!

Yeah I have looked a lotta places, and I talked to Turbo Hoses here in Livermore and they don't know about that piece either. He recommended a 3 to 4 round reducer, then a 4 to 4.5 that bends the 4.5 over the 4.25" oval part. W are gonna try to get the 3 to 4 piece to fit over the oval, which he said he has done one time, but it was a biatch!

Would really like to keep it to just one piece vs 2.

mdprovee · #10 05-02-2009, 09:11 PM

What about a rubber transition like mine. Goes from Round to oval.