Mopar Bigblock 383....Indy S/R, Edelbrock etc..

[rjsjea]

Selling a mopar big block 383. 0 miles since built, never run, professionally built and machined. $$$ 4,500

Indy S/R heads (professionally ported, aluminum)
KB hypeutetic pistons .030 over, 9.8-1compression
Balanced rods/steel crank...ARP hardware
BHJ sfi balancer
Comp cam XE275HL (hydraulic cam, 275/287duration, .525/.525lift 2k-5800rpm)
Smith Bros pushrods
Fabricated aluminum valve covers w/ breathers
Edelbrock RPM intake (powdercoated)
Holley Street Avenger 770cfm electric choke
Fuel log w/ fuel press gauge
K & N filter system
MP electronic ignition pckg (distributor,coil,orange ECU)
Champion wires on looms
Fabricated aluminum Charlies OIL pan (setup for single static p/u, Needs line and fittings)
MP flexplate

Motor is 500-525hp on pump gas, more potential if someone needed more power. My project has changed...of course so it's my lo$$ on this motor. Turned over and oiled regularly, stored in heated shop since built. Motor is painted in Epoxy DP90 (including heads). Oil pan, intake, valve covers are not sealed on for buyer inspection.....I have all gaskets to complete assembly included.

I am in Oregon (East of Portland) and will ship if necessary (buyer to pay), I have a motor stand and pallet for shipping if necessary.

No interested in trades unless you have a 6.1 hemi motor......questions, or more pics without valve covers/oil pan...plz ask --Rob