1st Gen CAMARO parts forsale.. the GOOD stuff... suspention, motor, wheels.. etc.

[Mr.VENGEANCE]

Looks like im going to do an Art morrison subframe so my suspention parts are forsale.

all parts were only mocked up, i never had the chance to ride on these at all.. sad but true..

so most of these are in "NEW" condition or like new..
of the ones i dont have pictures for ill get them later they are dusty from sitting there.

---- ATS AFX tall spindles for 1st gen Camaro.. used, great condition. SOLD TO MrQuick

---- Global West UCAs with Del-A-Lum buschings.. mocked up only new condition.. $500 shipped.

---- Speedtech LCAs.. mocked up only new condition.. $475 and shipping. SOLD to Steve Firebird

---- Hotchkis 2 inch drop coils with 1 coil cut.. $85 shipped. SOLD to Andrew mcBride
pictures below shown are the ride height with the coils.. pre coilovers.

---- Stock 67-69 front subframe, dirty but in GREAT shape with NO rust. $150 pick up only.

---- Brushed aluminum closeout panel "above the radiator" $70 and shipping.


---- NEW QA1 GMP14 Small Block Coilover Kit complete w/ QA1 spanner wrench and thrust bearing Kit.. fully adjustable. $415 shipped



---- SBC 406 chevy motor TH350 tranny.

The engine block was fully reconditioned
Edelbrock Performer RPM aluminum heads (64cc straight plug
chambers)
Edelbrock Performer RPM aluminum intake manifold
Lunati cast crank and pistons assembled for 10:00-1 compression
Lunati "number 10" 292/292, Lift.480/ .480
Holley 750 vacuum advance carburetor
GM HEI distributor
this is probably one of the best sounding and reliable motors out there with GREAT street manners. never had a problem with it..
engine is already pulled and ready to go.

Make and offer.


---- Boyd Coddington HARM 17x8 and 18X10s with Nexen tires.
215/40/17, 265/35/18 4.75" bs front and 5" bs rear
only ridden on them MAYBE 500 miles.. IF that.. they fit PERFECTLY 0n a 1st gen Camaro/Firebird. $1750 and shipping. i waited damn FIVE MONTHS for these wheels!


i didnt get to drive my car at all during the build.. and im starting over.. so these parts are up for sale.. i do accept paypal with the 3% fee must be included.

Im in ATLANTA if anyone wants to come and pic up.

[email protected]

email me or Im me here.

THANK YOU!

[Mr.VENGEANCE]

Sale pending on spindles..

[Mr.VENGEANCE]

ATS AFX tall spindles for 1st gen Camaro.. SOLD TO MrQuick

[Mr.VENGEANCE]

Speedtech LCAs SOLD to Steve Firebird