Next, a Detroit Speed steel dash face insert was used to house a full set of Autometer Carbon Fiber Gauges. We’ll install Volts, Fuel, Speed, Air / Fuel, RPM, Oil Pressure, Temp, and Vintage Air A/C controls in this panel.
Design sketched out
Measure 3 times!
Holes cut, A/C control going in for test fit
All holes cut, bodywork done and sprayed in satin charcoal to compliment the trim colors on the car.
Note 3 LED light holes above center gauge for turn signals and high beams.
All gauges installed and wired, with a weatherpack connector for easier installation.