Hey Fellas New guy from ATLANTA here..

[KillaCamaro67]

Hey guy here from good old Hotlanta..

I found this site through pro-touring.com

now introducing my 1967 Camaro

i just picked up a 67 Camaro with relatively stock body but swapped
a 406 cubic inch SB chevrolet. This engine is 6.6
The engine block was fully reconditioned (bored .030" over in
the process),
increasing displacement to 406 cubic inches.
Edelbrock Performer RPM aluminum heads (64cc straight plug
chambers)
Edelbrock Performer RPM aluminum intake manifold
Lunati cast crank and pistons assembled for 10:00-1 compression
Lunati "number 10" 292/
292, Lift
.480/ .480
Holley 750 vacuum advance carburetor
GM HEI distributor
The transmission is a TH350 3 speed automatic.
Hotchkis TVS coils.

the body of the car is in good condition and it being a georgia car has
little to no rust.. im pretty excited to get this rolling.

heres some photos.









cool.. well thats it.. hope you guys approve!

[KillaCamaro67]

forgot the engine shot!

sorry its dirty.. gotta clean it up!

[67Sally]

Welcome to the forum.
W.

[Autokraft]

Welcome to the site. Nice Camaro!


Kurt



www.autokraft.org