Lt1 T56 - Lateral-g Forums

**Swain** · #1 06-13-2011, 10:18 AM

I have a LT1 T56 out of a 94 pontiac.

I was going to run a SBC but decided to go to LS1 what would I need to get to make it work?

Jay

Bad94 · #2 06-13-2011, 03:50 PM

You will need to change the input shaft and bell housing, and recheck all the backlashing.

I know that guys on LS1tech do this all the time and there is a company over there that will do it for like $400.

**Swain** · #3 06-13-2011, 04:21 PM

Quote:

Originally Posted by Bad94

You will need to change the input shaft and bell housing, and recheck all the backlashing.

I know that guys on LS1tech do this all the time and there is a company over there that will do it for like $400.

Thanks for the info.

I will check into it.

79ZED · #4 06-15-2011, 03:53 PM

You'll also need the adapter housing that goes between the bell and the transmission. Don't forget to change the hydraulic components as well.

John

awr68 · #5 06-15-2011, 11:13 PM

This is all great info guys! Doesn't sound like like I have to buy a new T56 if one day I too enter the LS world! A few hundred bucks sounds a lot better than a new trans!