Mandrel bent oval tubing?

[2kx2]

I am looking for someone that can supply or knows how to get oval tubing that is mandrel bent. I know that Dr. Gas can do it by bending it on the edge.

I am wanting the tubing to be bent on the flat side. Basically it would come out of the TB and bend down, go straight and then bend again into the intercooler.

Any suggestions and help is greatly appreciated.

[race-rodz]

spin tech

[californiacuda]

Burnes stainless

[TravisB]

i second spintech

[chicane]

Dr. Gas = Spintech...

Burns will edge bend but not flat bend.

[Impala TT]

Check out Woolf Aircraft. That's who I've got a lot of tubing from. http://woolfaircraft.com/

[Garage Dog 65]

If it's thin gauge - you can do it in a pullmax.