Twin turbo manifolds

[2keaton11]

Who makes a good set of headers/ manifolds for a TT setup on a ls3 in a 1st gen camaro. I found a complete TT kit for a SBC for 800 bucks with brand new turbonetics 56mm turbos, gauges, manifolding, everything new but I don't want to buy yet if headers are going to be 2gs and car isn't complete yet. I would like ones that mount them at the front of the engine. I have a street and performance front accessory drive kit.

[barrrf]

XS Power has a set of stainless with T3/T4 flange for around $300 I think.

[John510]

Stainless works, virginia speed, OBX

[Golden_pilot]

I ended up buying my headers from this guy.

http://ls1tech.com/forums/parts-classifieds/1530612-lsx-stainless-turbo-headers.html

I was working just to the north of him in Buffalo WY, so I drove down to pick them up. Pretty good guy, said he has BBC and SBC headers to.

[gnx7]

For LSx swaps you can also run truck manifolds flipped forward (reverse the side they came on). If you need more clearance cut off the 3 bolt flanges and weld on Vbands. 2.25" crossover will support over 1500hp. 2.5" crossover will flow 2000hp with truck manifolds. The Ohio Boys who ran a built LS2 single turbo went 200mph in the 1/4 mile running truck manifolds in a 4th gen Fbody full weight.

[slownova73]

Truck Mani's

[2keaton11]

Thanks for the help guys. The car should be going to paint in a couple weeks and once completed ill prob put a couple thousand miles on it then jump into the TT setup. Hopefully.