PDA

View Full Version : frame bending question???


69charged
02-21-2006, 10:39 AM
hello all. i am currently building a 69 charger but have run into rotten frame rails. i have contacted a frame builder about bending new rails which would not be a problem but the distance from where i live is. does anyone out there know of a shop that can bend 2x4 rectangle tubing without having to cut it located around north/south dakota or minnisota? i live in northern manitoba canada and these places would be much closer than washington.
if not then i have no choice but to go with the other shop. oh well.

thanks a bunch
clarence

jy211
02-21-2006, 10:53 AM
maybe try Fatman 704-545-0369 ???

B Schein
02-21-2006, 12:39 PM
Morrison is the only one I know of that can mandrel bend 2 by 4 tubing. it sounds like you already contacted them with reference to Washington.

69charged
02-21-2006, 01:00 PM
yes i did contact them. i didnt want to blatantly say that i did as some forum moderators dont like that kinda stuff. anyway thanks for the replies and i will be looking at fatman fabrications.
anymore???
clarence

rocketman
02-21-2006, 07:01 PM
skinnykidracecars (http://www.skinnykidracecars.com)

jmarsa
02-21-2006, 07:30 PM
These guys seem to make everything in house: http://autoweldchassis.com/index2.ivnu here's the link to frame bending: http://autoweldchassis.com/spec.ivnu

--JMarsa

69charged
02-22-2006, 01:56 PM
thank you guys. i contacted autoweld and they were excellent to deal with and cheaper than previously qouted. by about 300 bucks!!! i think i will settle on them.
again thank you for the replies guys!!!
ill be back!!!!! and with photos!!!!!!!!!!

clarence

jmarsa
02-22-2006, 07:54 PM
It will be good to hear feedback. I'm not familar with anyone here or at PT that has used them before.

--JMarsa