View Full Version : Jig or Rotisserie
jblaine86
10-05-2011, 01:12 PM
I am about to start a 67 camaro project. I have to replace the quarters and floor pans. (I am planning to use a one piece floor).I am on a budget and wanted to know if jig or a rotisserie would be best for the whole project. I only have space for one.
Thanks,
Jon
ironworks
10-05-2011, 02:23 PM
I am about to start a 67 camaro project. I have to replace the quarters and floor pans. (I am planning to use a one piece floor).I am on a budget and wanted to know if jig or a rotisserie would be best for the whole project. I only have space for one.
Thanks,
Jon
Jig is my opinion
GregWeld
10-05-2011, 03:34 PM
I am about to start a 67 camaro project. I have to replace the quarters and floor pans. (I am planning to use a one piece floor).I am on a budget and wanted to know if jig or a rotisserie would be best for the whole project. I only have space for one.
Thanks,
Jon
Jon -- The rotisserie is fine AFTER the floors etc are in.... Block it and brace it on a solid surface while doing the work.
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.