Jig or Rotisserie [Archive] - Lateral-g Forums

jblaine86

10-05-2011, 11:12 AM

I am about to start a 67 camaro project. I have to replace the quarters and floor pans. (I am planning to use a one piece floor).I am on a budget and wanted to know if jig or a rotisserie would be best for the whole project. I only have space for one.
Thanks,
Jon

ironworks

10-05-2011, 12:23 PM

I am about to start a 67 camaro project. I have to replace the quarters and floor pans. (I am planning to use a one piece floor).I am on a budget and wanted to know if jig or a rotisserie would be best for the whole project. I only have space for one.
Thanks,
Jon

Jig is my opinion

HRBS

10-05-2011, 12:29 PM

^^^ x2 !
Alot less flex.

GregWeld

10-05-2011, 01:34 PM

I am about to start a 67 camaro project. I have to replace the quarters and floor pans. (I am planning to use a one piece floor).I am on a budget and wanted to know if jig or a rotisserie would be best for the whole project. I only have space for one.
Thanks,
Jon

Jon -- The rotisserie is fine AFTER the floors etc are in.... Block it and brace it on a solid surface while doing the work.