Quote:
Originally Posted by GregWeld
Remember -- PIPE sizes are measured by SUBTRACTING 1/4" from the observed measurement -- so if you measure some "pipe size" as 1/2" -- it's 1/4" pipe. 3/4" observed - would be 1/2" pipe and so on.
Here's a link to Summit Racing - order 'em up buddy!
http://www.summitracing.com/search/D.../?autoview=SKU |
I think he's looking for some that will mount flush with the manifold. I've had a few that did, but that was just a combination of circumstances and tolerances, probably wasn't meant to do that. Being that pipe threads generally taper they will almost never end up flush with the hole they thread into.
The ones of mine that did end up flush I figured that the threads weren't correct, not tapered. There have been cases where I could have continued tightening them until they fell through the hole...................
However, with sealer they still worked, just didn't tighten up as normal, you had to stop tightening them when flush and let the sealer dry fully before use.
Jody