Fresh 408 SBC With World Heads

[sam1]

408 block with brand new rotating assembly installed - Scat cast crank, KB pistons, purchased as a set from competition products.

World product heads the have been completely gone through, ported, flowed, comp valvetrain, setup for roller cam. $700 in head work, and have the flow numbers.

Asking $2700 OBO for Block/Rotating Assy/Heads - also comes with brand new Edelbrock RPM Air Gap Intake, Holley 725 CFM Street Avenger Carb, full gasket set. Needs a cam kit and ready to go.

Built for street use in a 69 PT camaro that is now gone. PM for pics, will post later, but Imageshack is down right now. In Austin, TX

John
512 748-5677

[sam1]

PICS



http://img520.imageshack.us/img520/6286/picture010om7.jpg (http://imageshack.us)

http://img510.imageshack.us/img510/76/picture013li8.jpg (http://imageshack.us)

http://img510.imageshack.us/img510/7752/picture016us0.jpg (http://imageshack.us)

http://img510.imageshack.us/img510/2576/picture014vz9.jpg (http://imageshack.us)

[Fluid Power]

location?


Darren

[sam1]

edited, but Austin, TX Thanks...

[sam1]

Head specs: World Products Aluminum

64cc/215cc
Comp Springs: 977-16
Comp Buckets: 4707-16
Comp Retainers: 740-16
Comp Keepers: 611-16

Serviced, Machined, Ported and Flowed, 0 run time since this work.

Flow numbers:

@ .450 224INT/176EXH
@.500 230/180
@.550 226/183
@.600 228/184

Will separate heads/Block/Intake/Carb

[JUSTANOVA]

What Does This Have For Rods?

[sam1]

The are 5.7 rods from competition products - ground for stroker clearance. Listed as their part number - 8043335 - Desc: Custom Rods Stage 2

Can be found at competitonproducts.com

Have receipts for Balanced rotating assembly, and head work - $1600 alone.

Thanks,
John

[sam1]

Bump - need cash

$2250 for everything...

[sam1]

Sold!!!!