Hotchkis rear upper adjustible control arm problem question for GM A-Body??

[staged67gspwr]

I`m in the process of doing the installation when i noticed on the upper control arm specifically the drivers side i had to put a notch in it cause it would not fit due to it hitting the rear end housing,has anyone experienced this problem with their`s on their GM A-Body?


Thanks

[Gordz32]

Something ain't right, take a picture and post it!

[staged67gspwr]

Here are 2 pics,1 is before i notched it.

[nowukno]

what size is that rear end? 10 bolt,12 bolt? that may be the problem

[staged67gspwr]

what size is that rear end? 10 bolt,12 bolt? that may be the problem



Its a `67 Chevelle 12 Bolt rear.


Thanks

[nowukno]

Its a `67 Chevelle 12 Bolt rear.


Thanks
I wonder if hotckis sent you a 10 bolt arm,the 12 bolt should be angled were it mounts to the ears of the diff

[nowukno]

these are the upper none adjustables for the 67 velle,note the hole location on these
http://i143.photobucket.com/albums/r142/nowukno_photos/1200.jpg

[staged67gspwr]

I wonder if hotckis sent you a 10 bolt arm,the 12 bolt should be angled were it mounts to the ears of the diff



I dont know dude,maybe i`ll call them tomorrow and see what i can come up with??

[staged67gspwr]

Just checked out Hotchkis websight and they list the same part # for 10 and 12 bolt?


Thanks

[nowukno]

Just checked out Hotchkis websight and they list the same part # for 10 and 12 bolt?


Thanks
ok buddy.good luck