Roller wheel question

[Frankenstine]

Hi everyone. Hoping my 1969 Camaro becomes a Roller later this year. It will have Detroit Speed Hydro Subframe and Detroit Speed Quad link rear with Ford 9 inch . Thinking I seen where someone used some Dodge Charger/Challenger spare tires to make there’s a roller but can’t remember what year they used . Anyone remember the post or know if this will work ? Thanks

[camcojb]

Depends on your bolt pattern. If it's still chevy 5 x 4.75" then the Mopar wheels would not work. If your axles and hubs have the Ford BC 5 x 4.5" they'd be right.

[Frankenstine]

Depends on your bolt pattern. If it's still chevy 5 x 4.75" then the Mopar wheels would not work. If your axles and hubs have the Ford BC 5 x 4.5" they'd be right.
Thanks Jody Been following your build. Looks awesome.

[CJD Automotive]

Yeah, I use them as rollers on pretty much everything. Anything 2005 and up are all pretty much the same and cost about $5-10 at the pull-it yards. I have slotted the lug openings (die grinder and about 2 minutes a wheel, and can fit them on anything from 4.75-5.5. Slotting the lug openings ruins it as a spare or driver, but they are just rollers.

[Frankenstine]

Yeah, I use them as rollers on pretty much everything. Anything 2005 and up are all pretty much the same and cost about $5-10 at the pull-it yards. I have slotted the lug openings (die grinder and about 2 minutes a wheel, and can fit them on anything from 4.75-5.5. Slotting the lug openings ruins it as a spare or driver, but they are just rollers.

Yes sir thank you very much for the information, I’ll have to check some you pull it’s around here