GM IdidIT column

[XLexusTech]

OMG ready to loose it after loosing so much time today.
Anyone know the thread and pitch on IdidIt column nut for the steering wheel?

I see lots of wheel tool kits have 9/16 -18 threads... before i overnight a kit wanted to ck here


ordered based on https://www.summitracing.com/parts/idt-9200041740

[Bad Bowtie]

Lexus,
If your looking for just the nut here is what I've read fits.

https://www.summitracing.com/parts/idt-2620000200?seid=srese1&gclid=EAIaIQobChMIiPfxweqa7QIVR4VaBR0MHw_IEAQYAyAB EgL8XvD_BwE

BB

[camcojb]

Probably too late, but mine is 9/16" fine thread.

[XLexusTech]

SO here is more info... I needed to adjust the directional lever and made the mistake of removing the C clip. NO big deal right well not so much.. the Idid it column uses a 65 lb spring to load the upper bearing. that spring is held in with the horn contact.... and a c-clip.... Ididit provides a kit with a tube.. to lock it in.. but i wasn't going for it..

TLDR.. ordered a cheap puller kit from amazon.. needed the thread pitch to make sure the tool would work.. paid 20 bucks was worth every penny..