View Full Version : DSE control arms 1st gen camaro with ATS afx spindles
akrapovic
10-08-2020, 06:07 PM
Need some help. I have a 69 camaro with stock subframe, dse control arms and ats afx tall spindles. I'm at the point where I'm going to get an alignment. Which alignment specs would/ should i follow? DSE or ATS/speedtech.
Im a suspension newb so I realize this may be a dumb question. Regardless, thanks for the help.
Marcus
68LS1
10-08-2020, 06:44 PM
I run same set up, DSE upper arms and tall spindle. We have mine set up at
Caster 5 degrees
Camber -0.5
Toe in 1/16 total
Drives nice and straight
akrapovic
10-08-2020, 06:57 PM
I run same set up, DSE upper arms and tall spindle. We have mine set up at
Caster 5 degrees
Camber -0.5
Toe in 1/16 total
Drives nice and straight
Did you setup for track or are these specs intended for more of a street car. I'm looking for street setup.
Also thanks for the info.
Musclerodz
10-08-2020, 07:41 PM
Did you setup for track or are these specs intended for more of a street car. I'm looking for street setup.
Also thanks for the info.
Those numbers work good on street. Its basically the same numbers I use.
Beechy
10-08-2020, 10:04 PM
Great advice from both 68LS1 and Musclerodz......go with those numbers.
FWIW.....I have run more caster (7 or8) but had to back it down to 5 cos understeer in the wet.
68LS1
10-09-2020, 05:06 AM
Did you setup for track or are these specs intended for more of a street car. I'm looking for street setup.
Also thanks for the info.
For the street, it is pretty fun through local twisty roads :)
akrapovic
10-09-2020, 11:49 AM
Thank you so much guys. Im going to give those specs a shot
vBulletin® v3.8.11, Copyright ©2000-2025, vBulletin Solutions Inc.