PDA

View Full Version : Transmission angle?


SS454
08-28-2006, 09:08 PM
OK, I'm ready to put the T56 in my 70 Chevelle to check the fit on the newly modified tunnel and to get some measurements on the crossmember. With the motor and trans bolted together and bolting the motormounts to the frame, what angle should I be shooting for, and where do I measure this at, the tail shaft or maybe the shifter plate? What angle should the carb plate be at also? I hope these are'nt stupid questions.

71Nova
08-29-2006, 01:15 AM
You need to make the output shaft of the tranz parallel with the yoke shaft in your rear end.