67-69 camaro Nu-relics door wire boot picture?

[130fe]

I was wondering if someone with Nu-Relic power windows can either post up or send me a picture of the boot placement (where you drill the hole) on the body side. I have the paperwork from Nu-relic and it only shows the door side. Any help or info would be appreciated.

[Tim john---]

There should be a (factory) dimple in the cowl side for location. Door and cowl both have the dimples from the factory if you have original body panels.

Tim john---

[130fe]

I know that Tim but the Nu-Relics instructions say not to use them. The boot has 2 90s in it and the instructions say to drill offset of the factory dimples. Looking for what the correct orientation for them is as a reference. The holes are 7/8" so I don't want to mess it up the first time LOL Thanks!
Chris

[Tim john---]

Chris, I just installed Nu-Reluics power windows in our 69 Firebird convertible and I purchased reproduction original style rubber door boots and drilled my holes to factory specs and ran my Nu-Reluc wires through them. Worked out very well for me. Perhaps pick up some reproduction rubber boots and do the same ?

Tim

[130fe]

Thanks Tim, might end up going that route if I cant get any get info pretty soon.

[Hutch69]

Where did you buy the aftermarket boots?

[Tim john---]

I purchased mine through AMES Performance in New Hampshire. 1-800-421-2637 (AMES). My car is a 69 Firebird, assuming Camaro would be the same.

Tim john---