New 2nd Gen four link released at SEMA!

[Josh@Ridetech]

63570
63571
63572
63573
63574
63575
63576
63577
63578
63579

[WSSix]

Glad to see new, innovative products still being made for the 2nd gens. Will this work with the factory rear end? From the looks of it, the axle tube diameter is all that's critical for connecting up to your components.

Thanks for sharing, Josh. Enjoy your time out there.

[Josh@Ridetech]

Glad to see new, innovative products still being made for the 2nd gens. Will this work with the factory rear end? From the looks of it, the axle tube diameter is all that's critical for connecting up to your components.

Thanks for sharing, Josh. Enjoy your time out there.

Correct! It is set up around a factory rear but has been installed with a 9" set up as well.

and no problem! :D

[bret]

Glad to see new, innovative products still being made for the 2nd gens. Will this work with the factory rear end? From the looks of it, the axle tube diameter is all that's critical for connecting up to your components.

Thanks for sharing, Josh. Enjoy your time out there.

You can use your factory rearend. The oem leafspring brackets will be removed and our upper and lower bar brackets will be welded on. We have jigs available to properly locate these brackets. We also give you measurements and an assembly procedure so you can locate them without the jig.
Ridetech and Currie will be offering complete rearend housings with Ridetech bracketry already installed.

[WSSix]

Thanks Bret!