mounting Poly mount to T-56 hardware

[paulk68]

can anyone tell me what hardware and sizes are needed to mount my poly trans mount to my t-56 magnum? my directions say use original hardware but i dont have any of that. Thanks

[DEIGuy38]

Found this on LS1 Tech, I used the stock hardware and this seem right. I believe Home Depot or Lowes will have these in the parts bins.

M10x1.50x40mm long. I ordered mine from Mcmaster Carr.

[paulk68]

Found this on LS1 Tech, I used the stock hardware and this seem right. I believe Home Depot or Lowes will have these in the parts bins.

M10x1.50x40mm long. I ordered mine from Mcmaster Carr.

Thank you Very much!! did you happen to put a washer on there also?

[DEIGuy38]

Thank you Very much!! did you happen to put a washer on there also?

Yes, i used flat washers on mount to transmission and lock washers at cross member to mount. See the attached from energy suspension
https://www.summitracing.com/parts/ens-3-1108r?seid=srese1&cm_mmc=pla-google-_-shopping-_-srese1-_-energy-suspension&gclid=CMa_6464jNMCFQRsfgodfFoN8w