Help ID LSX acc pulley.

[samckitt]

The 2 pulleys down by the AC compressor in this pic. It is on the Bandit TA from Year One. The pulleys look like something from Street & Performance. Looks to me like it puts the AC compressor down low but on the same belt as the main belt on the Vette acc drive.

http://ghostworks.yearone.com/wp-content/blogs.dir/4/files/bandit-build/bandit-build-action-2-002.jpg

[kevin_l]

Looks like street and performance setup to me. I've called and talked to them about that setup. I dont believe its in their catalog but they will make it for you. If you can run the aux belt then, Alan grove makes a low mount, and dirty dingo just release a very close fitting bracket sd7b10.

[samckitt]

Somewhere I read Street & Performance had closed.

I was wanting to try this to try to push the AC compressor forward as much as possible.

[dontlifttoshift]

I can't see the picture. :shrug: Is it this one?

http://st.hotrod.com/uploads/sites/21/2007/07/0710phr_05_z-1977_pontiac_trans_am-year_one_bandit.jpg

[samckitt]

I can't see the picture. :shrug: Is it this one?

http://st.hotrod.com/uploads/sites/21/2007/07/0710phr_05_z-1977_pontiac_trans_am-year_one_bandit.jpg

Shows the same content. The two aluminum pulleys down by the AC compressor is the ones in question. Pretty much decided it was from Street & Performance.