Steering options for S.Mock Subframe.

[Steve68]

I'm finally getting around to assembling my sub frame, I know I need to use a 3/4x16 u joint, but I'm trying to figure out what the best route on this,

I see CPP make a Collapsible steering shaft that goes from the stock column to the rack,

http://www.ebay.com/itm/CPP-Collapsible-Steering-Shaft-3-4-x-36-U-Joint-13-16-x-36-Rag-Joint-/282320740173?vxp=mtr&hash=item41bba09f4d

Then there's Speedtechs version, which you get the adapter from factory column to the u joint to the rack,

http://www.speedtechperformance.com/index.cfm/page/ptype=product/product_id=417/category_id=25/mode=prod/prd417.htm


just picking some brains while I'm home assembling this,

[Steve68]

Talked to Scott, I'll check with Jegs, also, working on other parts as well,

[Steve68]

Anyone have any certain experience with stainless u joints, good, bad, indifferent?

I know I'm not the only one on this site that's used a aftermarket sub,

[Ketzer]

Anyone have any certain experience with stainless u joints, good, bad, indifferent?

I know I'm not the only one on this site that's used a aftermarket sub,

Which did you pick? I just went with steel because I intended to paint it all black, if stainless I would have wanted to polish it all up...

[Steve68]

nothing yet,