lsuguy
07-25-2015, 06:59 AM
I have a Ford 9" setup from Speedtech with Torino Bearing ends.
They shipped with these style bearing plates:
http://www.summitracing.com/parts/msr-9750/overview/
However the bearings on the axle do not seat completely flush with the axle housing so there is a space between the bearing plate and the face of the housing. Is there a better solution to this? Seems like there should be some type of spacer between the bearing place and the housing. I measured everything out and I am bottoming out the axles.
The bearings are already pressed on the axle. If someone can link me to what they are using that would be very helpful. I should also mention that I do not currently have my rear brakes installed. So it may be that the spacing will be taken up by the parking brake assembly?
Thanks guys!
They shipped with these style bearing plates:
http://www.summitracing.com/parts/msr-9750/overview/
However the bearings on the axle do not seat completely flush with the axle housing so there is a space between the bearing plate and the face of the housing. Is there a better solution to this? Seems like there should be some type of spacer between the bearing place and the housing. I measured everything out and I am bottoming out the axles.
The bearings are already pressed on the axle. If someone can link me to what they are using that would be very helpful. I should also mention that I do not currently have my rear brakes installed. So it may be that the spacing will be taken up by the parking brake assembly?
Thanks guys!