gnx7
05-07-2015, 12:36 PM
Item Location (City/State): San Ramon, CA
Price: $80
Description:
2007 truck motor pullout with just over 100K miles. A lifter wheel failed and was making noise which wore out the cam. No damage to the block. All these parts were hot tanked and are super clean now.
4.0" bore alum block with main caps/bolts, crank sensor
(could be honed/reused at this bore, but .005" over preferred by my machinist) $sold
stock 3.622" crankshaft with 58x wheel $80
(needs to cut .010"/.010" due to the journals having scoring on them)
LS2/LS3 style rods with stock 4.0" pistons $200
(skirts look good and very little wear)
lifter valley cover with o-rings $50
rear cover $40
front cover with sensor $80
I can ship anywhere which is additional. Order of preference will be by posting a reply to this thread. Payment must be received within 48hrs or next person in line is up.
Price: $80
Description:
2007 truck motor pullout with just over 100K miles. A lifter wheel failed and was making noise which wore out the cam. No damage to the block. All these parts were hot tanked and are super clean now.
4.0" bore alum block with main caps/bolts, crank sensor
(could be honed/reused at this bore, but .005" over preferred by my machinist) $sold
stock 3.622" crankshaft with 58x wheel $80
(needs to cut .010"/.010" due to the journals having scoring on them)
LS2/LS3 style rods with stock 4.0" pistons $200
(skirts look good and very little wear)
lifter valley cover with o-rings $50
rear cover $40
front cover with sensor $80
I can ship anywhere which is additional. Order of preference will be by posting a reply to this thread. Payment must be received within 48hrs or next person in line is up.