4l80 in first gen

[waynieZ]

Does anyone have some pictures of a 4l80 in a first gen and how much room is there for the cooling lines? My trans is a 97 and newer with one port in front and one near the rear of the trans. Has any one ever used the banjo fittings they have for the trans cooling lines ? I would only use them if it was tight.
Not sure how I feel about them

http://www.ebay.com/itm/6AN-4L80E-GM-transmission-oil-cooler-90-degree-Banjo-fittings-low-profile-/231278300872

Thanks!

[Schwartz Perf]

Sorry, I don't have any pics of the 69 we did with a 4L80 of that area. But I think the front port was tight, and the rear one was not.

We've used the banjo fittings quite often. If you can get away with using the stock rear fitting you can use one of these: http://www.purechoicemotorsports.com/index.cfm/page/ptype=product/product_id=338/category_id=101/mode=prod/prd338.htm

Here's banjo's individually too:
http://www.purechoicemotorsports.com/index.cfm/page/ptype=product/product_id=408/category_id=101/mode=prod/prd408.htm

-Dale

[69x22]

I was wandering myself if a stock floor board would clear the 4L80?

[Bad Bowtie]

I was wandering myself if a stock floor board would clear the 4L80?

X2 This is on my list for my wife's Camaro I'm getting started on soon.:popcorn2:

BB