GM 4l60E for Camaro swap?

[Sonar Chief]

I would like to know which GM 4L60E tranny has a bell housing for a SBC and the tailhousing similar to the TH400. I have a connection to get one .... just don't know which?

Any suggestions would be appreciated .... I need one that I can rebuild w/o buying parts to make work, if there is such a tranny already set up from GM.

Thanks again .... chime in!

[Tim john---]

I have a 35,000 mile 4L60 out of a 2004 GTO available. Completely stock, I am using the GTO engine and will purchase a T-56 Tremec in the near future. The transmission has been removed and set aside (indoors)for a rainy day, someone in need. If you are interested let me know and perhaps we can work something out that is fair for the both of us.

Tim john---

[Schwartz Perf]

Not sure about the tail shaft.. But most of the 90's 4L60E's will work. You can tell the LS versions from the SBC versions because the LS ones are a full circle, ie. no removable inspection cover. 2 bolt holes on the bottom attach to the oil pan.
For electronic controllers I highly recommend the US Shift unit by Baumann electronics. Easy to tune & cheaper than most.

-Dale

[Sonar Chief]

I have a 35,000 mile 4L60 out of a 2004 GTO available. Completely stock, I am using the GTO engine and will purchase a T-56 Tremec in the near future. The transmission has been removed and set aside (indoors)for a rainy day, someone in need. If you are interested let me know and perhaps we can work something out that is fair for the both of us.

Tim john---


PM'd


Not sure about the tail shaft.. But most of the 90's 4L60E's will work. You can tell the LS versions from the SBC versions because the LS ones are a full circle, ie. no removable inspection cover. 2 bolt holes on the bottom attach to the oil pan.
For electronic controllers I highly recommend the US Shift unit by Baumann electronics. Easy to tune & cheaper than most.

-Dale


Thanks Dale ... I have seen the SBC ones then, w inspection covers. That is what I needed to know!

Monster said I needed a 1 piece pre 98 case? I wrote him back to see ...

[Sonar Chief]

Not sure about the tail shaft.. But most of the 90's 4L60E's will work. You can tell the LS versions from the SBC versions because the LS ones are a full circle, ie. no removable inspection cover. 2 bolt holes on the bottom attach to the oil pan.
For electronic controllers I highly recommend the US Shift unit by Baumann electronics. Easy to tune & cheaper than most.

-Dale

Dale ... what years and models did this come in from GM?

Thanks,

Michael

[71455Formula]

LT1 Fbodies, vettes, v8 trucks(1500's).

[Sonar Chief]

I called Monster Trans and he said I needed a 1 piece case outa pre 98 to mate to the first gen SBC .... found a 96 camaro 4L60E for $125. Going to go get it Friday.

Thanks for all that chimed in .....

Michael