PDA

View Full Version : WTB DSE LS Headers

colorado80439
09-30-2014, 08:11 PM
Got DSE headers for an LS motor?
Contact Dave thanks
badazz81z28
10-01-2014, 06:31 AM
X2 lol :military: :military:
jeremy30thz
10-01-2014, 08:12 PM
I have Stainless Works headers that fit DSE subframe
colorado80439
10-01-2014, 09:43 PM
I have Stainless Works headers that fit DSE subframe

Thanks Jeremy, I'm in!! just send me some pics of fitment in the dse frame with and ls engine, steering coupler configuration to the rack, and height in relation to the bottom of the subframe.
Thanks Again
Schwartz Perf
10-01-2014, 10:19 PM
I have a set that we used for mockup on a car, didn't work out (SW thought they'd fit rear steer rack & pinions too) . They're in perfect shape.

I'd sell for $750 shipped. I can get some dimensions if you need, email me at [email protected]

-Dale Schwartz
badazz81z28
10-02-2014, 05:56 AM
I have Stainless Works headers that fit DSE subframe

Hows the ground clearance?
colorado80439
10-02-2014, 07:39 AM
I have a set that we used for mockup on a car, didn't work out (SW thought they'd fit rear steer rack & pinions too) . They're in perfect shape.

I'd sell for $750 shipped. I can get some dimensions if you need, email me at [email protected]

-Dale Schwartz

Hey Dale thanks for the reply, what do you mean "didn't work out".
Thanks Dave
Schwartz Perf
10-02-2014, 08:11 AM
As stated right after "they didn't work out" - SW thought they would fit a rear-steer rack & pinion but they only fit a front steer r&p like the DSE.

-Dale
jeremy30thz
10-02-2014, 06:08 PM
As stated right after "they didn't work out" - SW thought they would fit a rear-steer rack & pinion but they only fit a front steer r&p like the DSE.

-Dale

Hey Dale,
What style headers did you try? CALS1, CALS1SB or CA679WD?
Schwartz Perf
10-03-2014, 10:19 AM
Hey Dale,
What style headers did you try? CALS1, CALS1SB or CA679WD?

CALS1.

SB is for stock box, wouldn't have tried them on a car with a steering rack.
They had a tube basically right where the steering rack U-joint goes, and no room to move around the tubes.

-Dale
jeremy30thz
10-03-2014, 12:46 PM
CALS1.

SB is for stock box, wouldn't have tried them on a car with a steering rack.
They had a tube basically right where the steering rack U-joint goes, and no room to move around the tubes.

-Dale

Might want to try the CA679WD on your frame, they fit a little better than
the CALS1...I have a few sets if you want to try one pm me and we might can work something out