View Full Version : 3 Point seat belt upper mount
renegade6
09-14-2014, 07:54 PM
I need some ideas on where to mount the upper portion for my three point seat belts. I am thinking along the B pillar (#2 in picture) but, it isn't as well reinforced as newer cars the same issue goes for #1; it's not reinforced very well. I could put it on the lower point (#3) and it would be much easier to reinforce but, I'm a little concerned that it would be too low. I'm open for suggestions.
Thanks
ADiCarlo
09-14-2014, 08:11 PM
Is this for daily use or track use?
By the position of the number I assume it's for the front seat. Do you have a design in mind?
My two cents.....
You might also go to the Schroth website and check their technical page on mounting. It may give you some ideas.
renegade6
09-14-2014, 08:44 PM
Mostly daily use with some track time. I have some ideas for building the reinforcement plate, just need to pin down the location for it.
I have thought about putting a harness bar in it and running Corbeau retractable harness belts.
Is this for daily use or track use?
By the position of the number I assume it's for the front seat. Do you have a design in mind?
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.