View Full Version : DSE Quadra link install
camcojb
09-08-2014, 04:52 PM
Here's a quick write up that Scott did when he installed a Quadralink on his 69 Camaro.
DSE Quadralink install (http://www.lateral-g.net/tech_articles/DSE_quadralink_install/)
http://www.lateral-g.net/tech_articles/DSE_quadralink_install/QLassy3.jpg
Revved
02-02-2015, 10:38 AM
Great Writeup!
I will throw out a great plug for DSE... They include great installation videos with their products as well. I put an Alumaframe and rear deep tub kit in the current 67 Mustang build and found their videos very helpful!
l2azorback
07-14-2016, 10:07 AM
Very Nice write up! Thanks
MillerBuilt
08-13-2016, 10:27 PM
I know everyone has their method, but I highly advise against welding on the suspension brackets after the housing ends have already been installed.
At minimal an alignment bar and applicable fixture blocks/pucks should be used while welding the suspension brackets. This will keep movement to a minimum at the housing end.
Ideally, the suspension brackets would be welded on first, then the housing ends for a perfect installation.
Hope this is helpful in addition to the above nice write-up.
Jay
speed_m5
06-10-2017, 01:06 PM
Thanks for the write up
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.