Holley accessory brackets

[fillpot]

Guy's been thinking about swapping my truck accessories out for these but had a question,can I use my powersteering pump, alternator,etc with this, I know I would change out the p/s resivor because that is one of my problems being real close to a control arm bolt, any thing else needed, this is a trailblazer ls2 in a 69 Camaro btw. THANKS!

[Efi69Cam]

Guy's been thinking about swapping my truck accessories out for these but had a question,can I use my powersteering pump, alternator,etc with this, I no I would change out the p/s resivor because that is one of my problems being real close to a control arm bolt, any thing else needed, this is a trailblazer ls2 in a 69 Camaro btw. THANKS!

Everything but the PS pump will work. I have their bracket for the AC compressor and it looks like a nicer casting than the GM Alt/PS bracket on the other side.

[fillpot]

What pump corvette style? THANKS!

[69lsvert]

I just ordered the ac and alt bracket from Holley to move them to the top. I have the ls6 so maybe a lot different from yours. I'll let you know how they work out.

[fillpot]

Thanks!

[Efi69Cam]

What pump corvette style? THANKS!

Uses the C5 Corvette PS pump and reservoir.

[sebtarta]

This is the Holley Accessory Bracket

http://i5.photobucket.com/albums/y181/sebtarta/72BlueNova/engine/20140726_141309_zps993cc079.jpg

This is the kit
https://holley.com/products/accessories/drive_brackets/brackets_only/parts/20-132

I bought them separately on Amazon as it was much much cheaper. Use this link for all the part #s needed for assembly.

https://holley.com/document/199r10613rev7.pdf



The only concern I have is that if you have any UCA it might be to close once you add the shims for alignment using the recommended 6" PSP pulley .

http://i5.photobucket.com/albums/y181/sebtarta/72BlueNova/engine/20140726_142320_zpsf7f8adf9.jpg

--edit--
Forgot to add, 72 Nova

[67Rally]

The only concern I have is that if you have any UCA it might be to close once you add the shims for alignment using the recommended 6" PSP pulley .


You should be fine. I don't think you could shim the UCA out far enough for it to hit. And if the engine is going to move under acceleraion, it's going to move towards the passenger side.

Nice looking setup by the way!

[fillpot]

Man that does look great, I haven't had a chance to fool with the accessories lately been chasing a wiring issue, with this bracket I'll use the corvette pump and reservoir and that should be it? Im at work now I'll look at the fitment guide tonight. THANKS!

[sebtarta]

You should be fine. I don't think you could shim the UCA out far enough for it to hit. And if the engine is going to move under acceleraion, it's going to move towards the passenger side.

Nice looking setup by the way!

Thanks, most of the build is on ls1tech as you know.


Man that does look great, I haven't had a chance to fool with the accessories lately been chasing a wiring issue, with this bracket I'll use the corvette pump and reservoir and that should be it? Im at work now I'll look at the fitment guide tonight. THANKS!

Yes use the pump and reservoir as mentioned before.

[fillpot]

Sorry didn't even notice I ask earlier, btw can I use my pulley. THANKS!