2010 camaro tr6060

[69 blue coupe]

What u guys think about putting this trans into a 69 camaro with a l92? Should I or should I not

[gnx7]

i don't like the gearing in them as they are for a heavy pig. That is the main downside IMO.

the mainshaft (output shaft) has a 3 finger flange on it requiring an adapter to make it mate up to a more common 6 bolt flange and then a slip yoke built into the driveshaft. meaning more expensive driveshaft by a couple hundred or more.

http://www.driveshaftshop.com/domestic-driveshafts/chevrolet/camaro/2010-2011/2004-2006-gto-g8-camaro-cts-v-conversion-plate

the bellhousing is also one piece integrated into the front bearing plate.... so if you wanted to put on an SFI bellhousing it is a custom setup $$$.

Just get a T56 Magnum with the 2.66 1st gear ratio. Then 5th gear is nice and close (.80 ratio) to stay in your powerband.