T56 slip yoke installation

[Moparigno]

Hi,

I'm wondering if the slip yoke just go through the splined shaft on the transmission or it needs a bolt to be secured in place.

thanks,

Paolo.

[chr2002ca]

Just slips on with no bolt. It has to be able to slide back and forth to account for rear suspension travel.

[Moparigno]

ok, thanks. I guessed so. How much room I need to keep it from full insert position (when it stops to slip in ) ?

[DEIGuy38]

I was told about 3/4" to 1"

[spooty]

Yes, the 3/4" to 1" should be a good target. Be sure to measure with the wheels loaded as they would be on a drive-on hoist. Letting the wheels hang , as on a two post/ arm hoist will not get you a good measure.