rocketrod
02-13-2013, 06:22 PM
SOLD - Received deposit
I have a complete polished Vintage Air Front Runner setup for a SBC with A/C compressor, power steering pump, Stewart water pump, all pulleys, belt tensioner, hardware and seprentine belt. I also bought a new Canton aluminum power steering resevoir and had the main truss, brackets, spacers, etc acrylic clear powdercoated. The setup was installed on engine and ran for about thirty minutes, but never driven. The setup listed below cost over $2500 new. I am asking $XXXX shipped plus paypal fees.
Vintage Air Polished SPC Frontrunner w/o power steering p/n 174020SCA (http://www.summitracing.com/parts/vta-174020-sca), cost $1900
Detroit Speed Type II power steering pump, polished p/n 090901P (http://www.detroitspeed.com/productsall/090901P-strng-pmp.html), cost $310
Power steering hardline p/n 91702 (http://www.detroitspeed.com/productsall/091702-hrdlne-prssure-tbe.html), cost $60
I upgraded to a Canton aluminum power steering resevoir with -6AN fitting (http://www.summitracing.com/parts/ctr-77-261/overview/), cost $150
The main truss, brackets, spacers, etc were all acrylic clear powdercoated, cost $125
If interested I also have a set of A/C hoses from bulkhead to compressor and dryer w/ service ports.
I have a complete polished Vintage Air Front Runner setup for a SBC with A/C compressor, power steering pump, Stewart water pump, all pulleys, belt tensioner, hardware and seprentine belt. I also bought a new Canton aluminum power steering resevoir and had the main truss, brackets, spacers, etc acrylic clear powdercoated. The setup was installed on engine and ran for about thirty minutes, but never driven. The setup listed below cost over $2500 new. I am asking $XXXX shipped plus paypal fees.
Vintage Air Polished SPC Frontrunner w/o power steering p/n 174020SCA (http://www.summitracing.com/parts/vta-174020-sca), cost $1900
Detroit Speed Type II power steering pump, polished p/n 090901P (http://www.detroitspeed.com/productsall/090901P-strng-pmp.html), cost $310
Power steering hardline p/n 91702 (http://www.detroitspeed.com/productsall/091702-hrdlne-prssure-tbe.html), cost $60
I upgraded to a Canton aluminum power steering resevoir with -6AN fitting (http://www.summitracing.com/parts/ctr-77-261/overview/), cost $150
The main truss, brackets, spacers, etc were all acrylic clear powdercoated, cost $125
If interested I also have a set of A/C hoses from bulkhead to compressor and dryer w/ service ports.