hydraulic clutch lines

[usa-69z]

Was thinkin has anyone made there own clutch to master lines using the teflon braid ?
I did make all my fuel lines using the telfon braid for my injection and wondered is there any difference in pressures for clutch rather than fuel ? and will the anodized ends be ok with these type of fluids etc?
As my car is a RHD 69 camaro i need a longer piece from master to the hydraulic throwout bearing.

thanx , Gav:)

[MarkM66]

I've used braided brake line/hose to go from my master cylinder to my slave.

My local street rod shop has pre-made lengths.

[FrankZ]

Making your own lines is fairly simple..........but I would use steel ends not the aluminum.

[usa-69z]

Making your own lines is fairly simple..........but I would use steel ends not the aluminum.

ok , thanx Frank

[GregWeld]

ok , thanx Frank


Nothing wrong with using Braided SS BRAKE lines -- you can buy them in various lengths.... in either -3 or -4