18" NewGen Splitters with Nitto Tires

[SUAREZ]

New NewGen Splitters powder coated gunmetal centers $1800 w/tires!!!
front 18X7, 5 x 4.75 BP, 5.0 BS, polished outer, with Nitto 225/40/18 NT-555
rear 18x9, 5 x 4.75 BP, 6.0 BS, polished outer, with Nitto 275/35/18 NT-555
Have 2 sets of center caps, pollished and powder coated.

[72camaross]

What were these made for??

I like em!

[Beegs]

Nice wheels.....that vette is an accident waiting to happen:wow: Get some stands!

[Ummgawa]

Suarez,

Rules state you must tell us where you are located.

Nice wheel/tires, good luck with the sale!

[hifi875]

Nice wheels.....that vette is an accident waiting to happen:wow: Get some stands!

x2 that scares me just looking at it!!!!

[creekwood08]

Could anyone tell me if these would work on my stock 69 camaro. Bout to put c6/c5 brakes on and need bigger wheels and later down the road when i mini tub and narrow the rear Ill get a new set. Thanks everyone.


Suarez how much u thinkin to ship to 37055

[HRD]

x2 that scares me just looking at it!!!!

x3. There was a local guy that died when a block holding up his car broke with him under it.

[SUAREZ]

Suarez,

Rules state you must tell us where you are located.

Nice wheel/tires, good luck with the sale!



Jim, I'm in Miami, FL

[SUAREZ]

x3. There was a local guy that died when a block holding up his car broke with him under it.


Wow! Its my pops car, i'll tell him

[Beegs]

Wow! Its my pops car, i'll tell him

Amazing how little it takes to make one of those crumble! They are VERY strong when used for their intended application BUT people are always using them to hold cars up and it makes me cringe. Do him a favor and MAKE him use stands or wooden blocks...no matter what he says!

[tempered]

i am interested and would like to find out if they would fit my 66 pontiac tempest

[tempered]

can anybody verify that these will fit my car

[wmhjr]

can anybody verify that these will fit my car

I'm relatively confident that the front will fit. I'm not so sure about the rear. To run 275s, I had to modify my rear wheel houses and fender lip. I have very little clearance even having done that with my '66. At this point I have the maximum available room without notching the frame or widening the rear fenders.

[tempered]

thanks for you're reply i have the longer 12 bolt chevy rear in my car

[wmhjr]

thanks for you're reply i have the longer 12 bolt chevy rear in my car

That's not your problem. The problem is simply the amount of space in the rear wheel wells. Take off a rear wheel, and start measuring INSIDE the wheel houses. Look above the inside wheel well lip. I removed most of heat you see, and still 275s on 10" wheels (which result in a narrower cross section than the same tire on a 9" wheel) have very little clearance. Track width, ie the total width of your 12 bolt, only affects backspace.