Lt1 T56

[Swain]

I have a LT1 T56 out of a 94 pontiac.

I was going to run a SBC but decided to go to LS1 what would I need to get to make it work?

Jay

[Bad94]

You will need to change the input shaft and bell housing, and recheck all the backlashing.

I know that guys on LS1tech do this all the time and there is a company over there that will do it for like $400.

[Swain]

You will need to change the input shaft and bell housing, and recheck all the backlashing.

I know that guys on LS1tech do this all the time and there is a company over there that will do it for like $400.

Thanks for the info.

I will check into it.

[79ZED]

You'll also need the adapter housing that goes between the bell and the transmission. Don't forget to change the hydraulic components as well.

John

[awr68]

This is all great info guys! Doesn't sound like like I have to buy a new T56 if one day I too enter the LS world! A few hundred bucks sounds a lot better than a new trans!