Which spark plug wires to get?

[scherp69]

I've done a few searches, but can't find much. I'm going to be relocating my coils onto the subframe, just in front of the headers. I'm trying to find a universal spark plug wire kit, but haven't had much luck finding part numbers. The motor is a L92 and should be mid 500hp. I would prefer to have red wires to keep with the red paint. I'm not partial to any brand, so that's not an issue. Does anyone have any suggestions to some wires and if you know the part number that would be great. Thanks in advance.

[Rybar]

MSD part number 32079 red or 32073 black

[scherp69]

Thanks Ryan. I'll check those out. Of course they're not at the $60 end that they advertise. I'm never sure when they say LS1 if they will work or not.

[scherp69]

Is there a preference with wire brands. I've read pros and cons to both Taylor wire and MSD wires. I've always run MSD wires on my small blocks. I was looking at the 90 degree Taylor boots and think they would work really good to run under the headers. Thanks.

[strtlegal]

I run only Taylor's. I've used them on many of my SBC builds and have never had one fail on me.

I'm sure the MSD ones are very nice, I've just had really good luck with the Taylors. Which is what I'm currently running on my LS

[Rybar]

Mike let me know if you find a Taylor part# for an LS Universal kit with the 90* boots on the plug ends.

[scherp69]

Mike let me know if you find a Taylor part# for an LS Universal kit with the 90* boots on the plug ends.

Will do. I sent Mike at Muscle Rodz a message to see if he knows the part #. I found an old thread with him where he said all he uses are Taylor. He said he was going to get back to me so I'll let you know as soon as I hear back.