Which One-Piece Floor Pan

[johnnymac46]

I will be replacing the floorpan and the trunk pan on my 68 Camaro. My truck pan has a lot of pin holes in the center and crunched in the driver side which is why it will be replaced, the floor is flinstone status. I also need toeboards.

My question is one-piece floor pan is the best? or which companies should I avoid?

I did a lot of searching and found more than plenty of information on how to do the install, now I just need to know where to buy

Thanks for the Help!

[NovaBlue71]

I have used a few of the dynacorn 1-piece floors and fit has always been good. Bel-air Bobs has been a good source for alot of the floorpans,side cowls, etc, I've needed for the camaro's projects we have done. Joe :thumbsup:

[Ron Fox]

John, have you made a decision on a full floor?

I went with a full floor from Classic Industries. It looks good and my builder likes it but it's not in the car at the moment so I don't know what the fitment is.

Other guys on here know more about this then I do so hopefully they will chime in and help you out.

Thanks.

[redfire69]

Dynacorn here. Fit was good considering the tolerances of these cars. Not sure if others like Goodmark are actually the same source panel from overseas.

[Ron in SoCal]

I used the Goodmark piece and it went in well with just a little stretching. I read about a one piece full floor, trunk and frame rails from Bel Air Bob's over on Camaros.net that sounded interesting but it was high $$$$.

[johnnymac46]

I still haven't ordered anything I'm waiting until I'll be home for a little while should be ordering in the next few days or in a week

Thanks for all the input I'll do some more research and keep you posted on te outcome