PDA

View Full Version : Ford 9" Rear

jwalk
01-06-2011, 07:44 PM
It is 59.75" axle flange to axle flange. It has the Torino ends. The axles are Spicer alloy 31spline. 1350 pinion centered. It has brackets for multi leaf springs welded on it, set up for a second gen Camaro. It was professionally built by Coast Driveline & Gear and I have the receipt. It is brand new. The center section is a Trac-Lock Currie unit. It has 325 gears. It does not come with brakes as I will be using them on my new rear. This rear end cost $3121.98. I will take $2000 or best offer. Selling because I need a narrower rear and I want a Moser M9.

I am located in Sacramento CA. I prefer not to ship but I will at buyer's expense. Thank you.
jwalk
01-09-2011, 10:38 PM
Price dropped to $1800
The T-man
01-21-2011, 08:20 PM
PM me I'll take it
jwalk
01-22-2011, 12:35 PM
pm sent
jwalk
01-22-2011, 11:52 PM
sale pending
jwalk
03-10-2011, 09:37 PM
Never ended up selling. Back up for sale. Make me an offer. I am also interested in trades as well: Looking for a nice air compressor 60 or 80 gal with a 2 stage pump and or snap on tools. The rear will need a new paint job from moving it around. Here are some more pics.

Thanks,
Justin
MC71Nova
03-10-2011, 11:11 PM
PM sent. Sorry I just realized you're in Sacramento but still interested for $1800. Thanks.
jwalk
03-10-2011, 11:34 PM
pm replied
jwalk
03-16-2011, 03:31 PM
Bump!
TheCntrion
03-16-2011, 04:03 PM
are the leaf spring pads in the right spot to bolt it up to a first gen? not taking into account the width...
jwalk
03-16-2011, 08:30 PM
I measured the spring perches. The measurements aren't perfect but very close. Outside to outside was 59 1/2" and inside to inside was 39 1/8" I am not sure if that's the same on a first gen but I think it should be. If anyone knows please chime in. When I bought the rear I planned on hacking those brackets off cause I'm doing a tri 4 link.