xssive99
12-20-2010, 03:09 PM
Purchased this a couple months back and decided we are going to go with a stock suspension setup in the rear. So , this needs to go! Asking 250$
http://i56.tinypic.com/2isw85h.jpg
Rod End Specifications:
Chromoly Teflon Kevlar Male Rod End.
Thread Size: 3/4-16 (4 Qty RH & 4 Qty LH)
Ball Bore: .751"
Ball Width: .875"
Centerline Length: 2.875"
Thread Length: 1.750"
Radial Load Capacity: 27019
Approximate Degrees: 36
High Misalignment Spacer Specifications:
8 Pair (HMS) 3/4" to 1/2"
Insert Dia: .750"
Inside Bore: .500" or .625" (please specify)
Outside Boss Dia: .745"
Overall Length In Ball: 1.700"
Approximate Degrees: 27
Weld-in Threaded Bung Specifications:
Thread Size: 3/4-16 (4 Qty RH & 4 Qty LH)
Fits Tube Size: 1" 1/4 OD x .095 Wall
Jam Nut Specifications:
Thread Size: 3/4-16 (4 Qty LH & 4 Qty RH)
Width: 1 1/8"
Height: 27/64"
Clear Zinc Plated
http://i56.tinypic.com/2isw85h.jpg
Rod End Specifications:
Chromoly Teflon Kevlar Male Rod End.
Thread Size: 3/4-16 (4 Qty RH & 4 Qty LH)
Ball Bore: .751"
Ball Width: .875"
Centerline Length: 2.875"
Thread Length: 1.750"
Radial Load Capacity: 27019
Approximate Degrees: 36
High Misalignment Spacer Specifications:
8 Pair (HMS) 3/4" to 1/2"
Insert Dia: .750"
Inside Bore: .500" or .625" (please specify)
Outside Boss Dia: .745"
Overall Length In Ball: 1.700"
Approximate Degrees: 27
Weld-in Threaded Bung Specifications:
Thread Size: 3/4-16 (4 Qty RH & 4 Qty LH)
Fits Tube Size: 1" 1/4 OD x .095 Wall
Jam Nut Specifications:
Thread Size: 3/4-16 (4 Qty LH & 4 Qty RH)
Width: 1 1/8"
Height: 27/64"
Clear Zinc Plated