will these lowereing blocks work with my setup

[speedshftr]

i have a 68 camaro with a mono leaf rear.it needs about 3 inches lowered in the rear.the car is a slow cruiser and not a high hp car.i need inexpensive fix to get the rear down.will thse work for my setup.im running 18 inch rushforths also.
http://cgi.ebay.com/ebaymotors/67-68-69-CAMARO-LOWERING-3-REAR-LOWERING-BLOCK-KIT-/300314913046

[MarkM66]

I would think so.

[deuce_454]

lowering blocks cause spring wrap... uou need to install some sort of under or overrider tractionbars if you expect it to behave nicely with tall lowering blocks and full throttle/braking..

but yes they will work

[redfire69]

I posted this over a p/t, your car is turning out so nice, I would spend the extra cash and go w DSE 3 inch lowering springs and a multi-leaf conversion. Good luck-

[TA219]

I put some blocks under my car because even with Hotchkis lowering springs the rear was up pretty high (until the leaf springs settle in) but I found some at my local autozone that were much cheaper